Labconco FreeZone Bulk Tray Dryer 78060 Series - Manual (Page 16)

Chapter 4: Using Your Bulk Tray Dryer
Product Service 1-800-522-7658 12
Bulk Tray Dryer Controls
The control panel for the Bulk Tray Dryer is shown below with a description
about its function.
1. Main Power Switch- (Not shown- Located on left side of cabinet) turns the
unit on or off.
2. Run/Stop Switch- Initiates the Bulk Tray Dryer to control the temperature
of the shelves at the set point temperature. An “R” or “S” will appear in
the display at the left hand end to indicate the mode selected.
3. Increase and Decrease Switches- Used to change the set point temperature.
The set point temperature may be set from –20°C to +60°C.
4. Display- Displays actual temperatures, set point temperature and run or
stop mode.
5. Vacuum Release- Vents the chamber so the chamber door can be opened.
Operation Checklist
The following checklist should be followed prior to each use of your Bulk Tray
Dryer.
1. Wipe out the interior of the Bulk Tray Dryer chamber with a soft cloth or
paper towel to remove any moisture or debris.
2. Wipe the interior of the collector chamber of the Freeze Dry System with
a soft cloth or paper towel to remove any accumulated moisture.
4
2
3 5
3