Removing the shipping skid – Labconco Purifie Horizontal Clean Benches 32000 Series User Manual
Page 14
Chapter 3: Getting Started
Product Service 1-800-522-7658
10
Part #
Component Description
3208000
Purifier Clean Bench Owner’s Manual CD
3952900 Strap,
Lashing
3894400 Bracket, Tie-Down
1337100 Power
Cord,
115V
Or (one of the following)
1338000
Power Cord, 230V United States
1332600
Power Cord, 230V United Kingdom
1336100
Power Cord, 230V Schuko
1332700
Power Cord, 230V China/Australia
If you did not receive one or more of the components listed for your clean bench,
or if any of the components are damaged, contact the Labconco Product Service
Department immediately for further instructions @ 1-800-821-5525.
Removing the Shipping Skid
LEAVE THE CLEAN BENCH ATTACHED TO ITS SHIPPING
SKID UNTIL IT IS AS CLOSE TO ITS FINAL LOCATION AS
POSSIBLE. MOVE THE UNIT BY USING A SUITABLE
FLOOR JACK, OR BY PLACING A FURNITURE DOLLY
UNDERNEATH THE SKID. DO NOT MOVE THE BENCH BY
TILTING IT ONTO A HAND TRUCK.
After you verify the XT Clean Bench components, move your XT Clean Bench to
the location where you want to install it. Then, follow the steps listed below to
remove the shipping skid from your unit.
To remove the shipping skid:
1. Remove the plastic wrapping and packaging material from the bench.
2. Remove and discard the three brackets holding the unit to the skid, as shown
in Figures 3-1a and 3-1b.
3. Lift clean bench off of shipping skid using a mechanical lift, forklift, or two
pallet jacks with boards slid underneath the clean bench spanning the two
pallet jacks.
4. Set the four legs to desired working height by removing the four bolts,
extending each leg and replacing each bolt and washers, secure acorn nut
firmly. The integrated stand has three working height options. The lowest
hole will set the worksurface height at 29.2”, and each higher hole raises that
height by 1.5”. To raise clean bench off of its legs, use mechanical lift, fork
lift, or pallet jack with boards as shown in Figure 3-2.
5. Once in final location, adjust leveling feet to ensure clean bench is level.
)