D-Link DCS-900 - Manual (Page 48)

48 D-Link DCS-900 User Manual
Section 3 - Configuration
To add a new camera select the Camera button from the IPView SE. Make sure that the green lights are on when
clicking the camera button.
A green light under the camera
button means that there is already
a camera connected.
Select the camera you would like to connect to and click
Add A Camera. If the camera is not listed in this list,
click the
Input IP Address button. Enter the IP Address
of the camera in the specified field and click Add. If the
IP Address is entered incorrectly or if you have a bad
network connection, a dialog box will appear to notify
you of the error. To add cameras in IPView SE, check
that you have your network configured correctly. To add
a remote camera, you need to have Internet access.
If you are unsure of the IP Address of the camera, you can click on
Search to search for all available cameras that are installed on your
local area network.
Note: Only cameras on your local area network can be located using Search in IPView SE. If you want to add a camera via the Internet,
you must enter in a public IP Address. Please note that if your camera is behind a router, you will need to enter your router’s WAN IP followed
by a colon, then the port number that is assigned to your camera. As in example 10.10.10.80:800, where 10.10.10.80 is your router’s WAN
IP and :800 is the port that your camera is using.
Add a New Camera