Kipp&Zonen CFR Calibration Facility - Manual (Page 9)

CFR manual
8
Step 3 Remove the mains plug from the lamp housing power cable (if fitted) and pass the cable through
the lamp mounting pillar and cable gland.
figure 3 Lamp cable passed trough the lamp pillar
Step 4 Electrical connection of the lamp to the voltage stabilizer
115 VAC / 60 Hz Calibration Facility
The 115 VAC / 60Hz version of the CFR has all the electronic components for powering the bulb integrated
into the lamp housing. Re-fit the plug and connect directly to a suitable mains outlet socket. Connect the
voltmeter power cable to a suitable mains outlet socket.
230 VAC / 50 Hz Calibration Facility
Connect the lamp power cable to the voltage stabilization unit, as shown in figure 4. Fit the metal cover
and connect the voltage stabilizer and voltmeter power cables to suitable mains outlet sockets.
figure 4 Cable wires connected to the voltage stabilizer terminals
Warning: To prevent electric shock during installation, all electrical devices
must be disconnected from the mains power.
Label Function Cable Wire color
1 in Neutral Mains Blue
2 in Phase 230 VAC Mains Brown
Protective Earth Mains Yellow/Green
Earth Table Yellow/Green
3 out Neutral / Earth Lamp
Blue and
Yellow/Green
4 out Phase 230 VAC Lamp Brown
5 out - - -