Imaxrc X350 - Manual (Page 22)

31 32
Cut off Low Input
Backlight Level
Cut off Temperature
Buzzer
Cut off Capacity
Language
Cut off Time
Back
LixxCheckTime
NixxDeltaPeak
Waste Time
Cycle Time
Rang of setting:10-11V. Lowest cut off input voltage, charger will stop charging/
discharging when input voltage is lower than setting value.
Rang of setting: 1-10, Brightness level.
Rang of setting: 40-80°C. Cut off Temperature, charger will stop charging/
discharging when the temperature of batteries is lower than setting value.
Rang of setting: All sounds open, only touch tone closed, All sounds closed.
Rang of setting: 0.1Ah-15Ah. Safety capacity. Charger will Stop charging/dis-
charging when capacity of batteries is higher than setting value.
Language option. Now provisionally only support English interface.
Rang of setting: 10-200mins. Safety time, charger will stop charging/discharg-
ing, when charging/discharging time is less that setting value.
【IMPORTANT NOTE】 X350 charger has 3 parameters to control rotate speed of fan.
1. When temperature of working charger reach 40℃, fan speed will be one level up as
temperature rise by each 2℃
2. When charging power reach 100W, fan speed will be one level up as charging power
rise by each 5W.
3. Fan speed will be one level up as discharging power rise by each 2W.
4. Ciruit power: max.350Watts(charging input > 13.0V)
NOTE: Fan Speed of X350 charger will begin to change in any of above situation.
Turn back to main interface
Rang of setting: 5-60mins. Time for checking cells count of LiPo battery pack.
Rang of setting: 5-20mV. NiHm/NiCd Delta peak.
Spacing interval between 2 Cycles. Rang of setting: 1-60mins.
Rang of setting: 1-6 times. Cut off
Low
Input
Cut off
tempe-
raturey
Cut off
Capacity
Cut off
Time
Lixx
Check
Time
Nixx
Delta
Peak
Wasle
Time
Cycle
Times
Backlight
Level
Buzzer
Language
Back
Chapter 2 Enjoy function of X350 Chapter 2 Enjoy function of X350