HITEC Lynx FM - Manual (Page 6)

Rx Crystal
Tx Crystal
Throttle
Servo
Steering
Servo
5
■ ■ ■ ■ ■ Changing X-tals
Changing the x-tal to void conflicts with other vehicles is possible where permitted. (You must
check your local rules before doing so. For example, in the US, the FCC prohibits the changing
of transmitter x-tals on 72 and 75MHz). If you are eligible to change the x-tals, both the
transmitter and receiver x-tals must be changed together. You must change within the same
band, i.e. 75MHz to 75MHz, 27MHz to 27MHz, different bands can not be intermixed if your
radio is on 75MHz then 27MHz x-tals cannot be used. Use only Hitec x-tals when changing
frequencies.
2. Installation of Receiver and Servos
■ ■ ■ ■ ■ Using separate power source for the receiver
When using a separate power pack for the receiver instead of sharing the main power source,
please refer to the following diagram. After installation, turn on the power to the transmitter
first then turn the receiver on. (Always turn the transmitter ON first and OFF last.) This will
prevent the receiver from picking up stray signals and going out of control. Now, move the
controls to see if the servos are moving properly. If not, Check your wiring, battery charge or x-
tals if the servos do not move at all.
■ ■ ■ ■ ■ Battery Eliminator Circuitry (B.E.C.) Included in AM Model Only.