HITEC Lynx FM - Manual (Page 5)

CG-22 or CG-25A
#7201 Battery
Holder
#7401 RX NiCad
Battery
4
■ ■ ■ ■ ■ Recharging NiCad Batteries
The LYNX is equipped with an external charging jack so there is no need to remove the
battery pack from the transmitter. The Hitec CG-22 or 25A are made to charge these types
of batteries overnight or the approximately 12-15 hours. Please refer to the following
diagram, check to see that the charge light lights up after the connection is complete.
■ ■ ■ ■ ■ Transmitter Antenna
You must attach the transmitter antenna by screwing it into the hole located at the top left/
center of the transmitter. You may take the antenna out to store it. This storage area is
located on the backside of the transmitter. Always attach your antenna before use or you
will experience sever shortage of operating range that could result in damage to your vehicle
and or injuries to yourself and others.