D-Link DSC-100 - Manual (Page 9)

7
Using the DSC-100
Setting Camera Shooting Modes
Press and hold the Power button for 3 seconds to power on the camera.
Then press the Mode button to set the shooting modes. The mode will
change each time you press the Mode button.
Single Snap Shot Mode (Default Setting)
Only one picture will be taken every time you press the Shutter
Release button.
Single Snap Shot with Self Timer Mode
The camera will take pictures 10 seconds after you press the
Shutter Release button. The LED light on the front panel will
start to blink when you press the shutter button and stop
blinking after 10 seconds.
Continuous Snap Shot with Self Timer Mode
You can set the camera to take 1 to 10 continuous pictures with
a 10 second interval using the self-timer mode. Press the Mode
button until you see the Timer Mode icon appear. Press the
Mode button for 3 seconds and press the Forward " " or
Backward " " buttons to set the number of pictures to take.
Click the Shutter Release button to apply the setting changes.
Press the Shutter Release button again to start taking pictures.
If you want to stop taking pictures, press the Power button.
Tip: Use a tripod or other steady support to hold the camera when
using the self timer or continuous snapshot modes.