HITEC P-51 Mustang - Manual (Page 9)

ASSEMBLY INSTRUCTIONS - F4U CORSAIR (cont.)
Step 7: Installing the Receiver and Battery.
Install the receiver into the fuselage and plug
in the servo leads. Install the battery into the
cavity in the front section of the fuselage as
shown above.
STEP 7
Step 6: Attach the Auxiliary Fuel Tanks
To attach the auxiliary fuel tanks to the wings apply a small amount of glue and
position them in place on the wings.
STEP 6
Step 10: Center of gravity.
STEP 8
Step 8: Center of gravity.
Check the Center of Gravity on your
model by balancing it on your fi ngers. The
CG should be about 1 1/2 ~ 1 3/4 inches
(40 ~ 45 mm) behind the leading edge of
the model as shown below. You can adjust
the CG by moving the battery forward or
backwards.
- 9 -