HITEC P-51 Mustang - Manual (Page 14)

Flying Your Plane
Before taking off , perform a radio range check and make sure all your control surfaces are operating in the proper direc-
tion. Take off into the wind and climb to 50 feet to begin your trim out procedures. Once trimmed out, feel free to test the
performance of the plane by performing a variety of aerobatic maneuvers.
PREPARING FOR FLIGHT
The ESC is set for optimal performance at the factory and should not be changed. Before connecting the battery, make
sure the throttle is in the lowest (off ) position. If the throttle is not in the lowest, off position, the speed control will not
initialize. If this happens, you will need to disconnect the battery and repeat the initialization sequence.
SPEED CONTROL OPERATION
ADJUSTMENTS AND OPERATION
FLYING YOUR PLANE
Step 1: Turn on your transmitter making
sure the throttle is set to the lowest (off )
position. Leave all other sticks and trims
in their neutral position.
Step 1: Holding the tail of the airplane
apply a small amount of throttle to ensure
the motor is working and connected to
the ESC properly. Step 1: Now check to make sure all the
control surfaces are in their neutral position.
If not you can adjust them with the trims on
your transmitter.
Step 2: Connect your battery to the Electronic Speed control and close the
battery cover.
STEP 1
STEP 3 STEP 4
STEP 2
- 14 -