Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) - Manual (Page 67)

67 User Controls
OSD Menu Functions
IND100064-38
|--------3--------
Management Settings - Graphic Scaling - Horizont Stretch
All stretching will performed from center of active display area and outwards in one direction.
Settings as follows:
“Horizont Stretch” = Zoom/stretch current full screen signal in Horizontal
direction only (left and right). Values from 0 to 100.
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal’s 1.1 pixel information and properties. Default value is 50.
|--------3--------
Management Settings - Graphic Scaling - Vertical Stretch
All stretch will performed from center of active display area and outwards in one direction.
Settings as follows:
“Vertical Stretch” = Zoom/stretch current full screen signal in Vertical direction
only (up and down). Values from 0 to 100.
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal’s 1.1 pixel information and properties. Default value is 50.
|---2---
Management Settings - Auto Adjustment
Allow to let the video controller always perfom a Automatic Adjustment based on the detected
properties in the incoming signal or when incoming signal sources changes it’s properties real time.
It will scale and position incoming signal sources that has changed since the last detection was
executed successfully. Set to either “ON” or “OFF”.
● Note: This function is the same as the manual function found in “Image Settings - Auto Position” earlier described.
Default value is “OFF”.