Hanna Instruments HI 83746 User Manual

Page 9

Recommendations for Users
Before using these products, make sure that
they are entirely suitable for your specific
application and for the environment in which
they are used.
Operation of these instruments may cause
unacceptable interferences to other electronic
equipments, this requiring the operator to take
all necessary steps to correct interferences.
Any variation introduced by the user to the
supplied equipment may degrade the
instruments' EMC performance.
To avoid damages or burns, do not put the
instrument in microwave ovens. For yours and
the instrument safety do not use or store the
instrument in hazardous environments.

CE DECLARATION OF CONFORMITY

HI 83746 is warranted for two years against defects in workmanship and materials when used
for its intended purpose and maintained according to the instructions.
This warranty is limited to repair or replacement free of charge.
Damages due to accident, misuse, tampering or lack of prescribed maintenance are not covered.
If service is required, contact your dealer. If under warranty, report the model number, date of
purchase, serial number and the nature of the failure. If the repair is not covered by the warranty,
you will be notified of the charges incurred.
If the instrument is to be returned to Hanna Instruments, first obtain a Returned Goods Authorization
Number from the Customer Service Department and then send it with shipment costs prepaid.
When shipping any instrument, make sure it is properly packaged for complete protection.
To validate your warranty, fill out and return the enclosed warranty card within 14 days from the
date of purchase.

Hanna Instruments reserves the right to modify the design, construction and appearance of its products
without advance notice.

WARRANTY

Battery replacement must only take place in a
non-hazardous area.
The blinking “

” will appear when the batteries

power gets low.
When batteries are completely discharged, “0% bAtt”
will appear and after two seconds the instrument is
switched off.
Remove the battery cover from the bottom of the
instrument and change the old batteries with 4 fresh
1.5V batteries, paying attention to the correct polarity.
Replace the cover.

BATTERIES REPLACEMENT

REAGENT SETS
HI 83746-20

Reducing Sugars reagents set (ca. 20 tests)

HI 93703-59

Charcoal for decoloration of Red Wine (about 100 tests)

OTHER ACCESSORIES
HI 839800

Reactor

HI 740216

Test tube cooling rack (for 25 vials)

HI 740217

Laboratory bench safety shield

HI 731331

Glass cuvets (4 pcs)

HI 731340

200

L automatic pipette

HI 731350

Plastic tips for 200

L automatic pipette (25 pcs)

HI 731341

1000

L automatic pipette

HI 731351

Plastic tips for 1000

L automatic pipette (25 pcs)

HI 740232

Filter paper type I (100 pcs)

HI 731318

Tissue for wiping cuvets (4 pcs)

HI 731325W

Caps for cuvets (4 pcs)

HI 93703-50

Cuvets cleaning solution (230 mL)

HI 740027P

1.5V AA batteries (10 pcs)

HI 710005

Voltage adapter from 115V to 12 VDC (USA plug)

HI 710006

Voltage adapter from 230V to 12 VDC (European plug)

ACCESSORIES