Hanna Instruments HI 955201 - Manual (Page 16)

31 30
Allow approximately 5 cm (2") to exit from
the printer and replace the cover.
TO RESET PRINTER
To reset a jammed printer,
press the PAPER key.
If the printer is still
jammed, remove the
battery cover on the
rear of the meter, and
press the RESET
black button using a
sharp pencil . This will
reset the printing
mechanism.
Before replacing the battery cover investigate
the cause of the printer jam (e.g. the paper
caught under the cover and prevented printer
from advancing paper feed).
Replace the battery cover and tighten the screws.
-
- +
+ 1.5V
1.5V
-
- +
+ 1.5V
1.5V
SCREW
POTS
RESET
PAPER
PAPER
PRINTER MAINTENANCE
CHANGING THE INK CARTRIDGE
When printouts become faint, it might be nec-
essary to change the ink cartridge. Contact
the nearest HANNA service center.
INSERTING THE PAPER ROLL
HI955201, HI955202, HI955301 and HI955302
use plain paper rolls, 38 mm width.
To insert a new roll open the paper cover by
pulling it gently.
Remove the carton cylinder.
Insert the paper edge in the printer slot and
feed the printer by pressing the PAPER key.