Hanna Instruments HI 955201 - Manual (Page 13)

25 24
UP DOWN
TIME LOG
ALT
TEMP
LOG
DOWN ALT
UP DOWN
ALT
TEMP
Step 5 - Viewing data stored in sample #1
Press the LOG key to enter the memory
recall mode. The next available log and page
number will be shown on the display.
Press the ALT and DOWN keys until "10"
and "L1" appear, indicating that a total of 10
samples were recorded in log #1.
To view the data stored in the sample #1, first
use the UP and DOWN keys to scroll through
the sample numbers.
Once the number is displayed, press the ALT
and TEMP keys. The date at which that
sample was taken will appear first.
Press UP to view the time.
10-01-96
==01== 0002M
0010 *00.18
DATE
LOG
The meter is now in printing/logging mode
using log #1, page 16. The "LOG" and P 15
indications on the secondary display mean
that the meter has entered the log mode and
has 15 pages of available memory remaining.
After the initial printout, the
time and printing/logging in-
terval will reappear.
Press the LOG key to view the current log
and page numbers.
Press the LOG key again to view the running
sample number.
Step 3 - Stopping the printer during log
mode
After the third printout is complete, press the
ALT and PAPER keys. The meter continues
to log data every 2 minutes, but it will no
longer print any information. "LOG" will keep
blinking on the secondary display as reminder
of "L 01" (log #1).
Note: If the display has shut off press TEMP
to reactivate it.
Step 4 - Leaving the log mode
Once the number of samples stored in memory
has reached 10, press the ALT and LOG
keys. The meter will exit the log mode after
generating a log exit status printout.
INTV
TIME
LOG
LOG
LOG
UP
PAPER
ALT
PRINT
LOG
UP
TIME