Hanna Instruments HI 145-00 - Manual

w w w . h a n n a i n s t . c o m
Instruction Manual
HI 145-00 • HI 145-01
HI 145-20 • HI 145-30
Rugged Thermometers with
T-shaped Handle and Cal-Check ®
IST145-R2 06/05
SPECIFICATIONS
HI 145-00 / -20 HI 145-01 / -30
°C °F
Range -50.0 to 220°C -58.0 to 428°F
Resolution 0.1°C(-50.0 to199.9°C) 0.1°F(-58.8 to 199.9°F)
1°C(200 to 220°C) 1°F (200 to 428°F)
Accuracy ±0.3°C (-20 to 90°C) ±0.6°F (-4 to 194°F)
±0.4% FS (outside) ±0.4% FS (outside)
Typical EMC ±0.3°C ±0.5°F
Deviation
Probe stainless steel
HI145-00/HI 145-01 125 mm x dia 5 mm
HI145-20/HI 145-30 300 mm x dia 5 mm
Battery Type 1 x 1.5V AAA
Battery Life approx. 10,000 hours
of continuous use
Auto-off after 8 minutes of non-use
Environment -10 to 50°C (14 to 122°F); RH 95%
Dimensions / Weight
HI145-00/HI 145-01
92x165x38 mm / 65 g
HI145-20/HI 145-30 92x340x38 mm / 80 g
Warranty
All Hanna Instruments meters are warranted for two years against defects in work-
manship and materials when used for their intended purpose and maintained according
to instructions. This warranty is limited to repair or replacement free of charge.
Damages due to accident, misuse, tampering or lack of prescribed maintenance are
not covered. If service is required, contact the dealer from whom you purchased the
instrument. If under warranty, report the model number, date of purchase, serial
number and the nature of the failure. If the repair is not covered by the warranty, you
will be notified of the charges incurred. If the instrument is to be returned to Hanna
Instruments, first obtain a Returned Goods Authorization number from the Customer
Service department and then send it with shipping costs prepaid. When shipping any
instrument, make sure it is properly packaged for complete protection.
Recommendations for Users
Before using this product, make sure that it is entirely suitable for the environment in
which it is used. Operation of this instrument in residential areas could cause inter-
ference to radio and TV equipment. Any variation introduced by the user to the
supplied equipment may degrade the instrument's EMC performance. To avoid elec-
trical shocks, do not use this instrument when voltage at the measurement surface
exceeds 24 Vac or 60 Vdc. To avoid damage or burns, do not perform any measure-
ment in microwave ovens.