Hanna Instruments HI 88713 User Manual

Page 16

REAGENT SETS
HI 93703-58 Silicon oil (15 mL)
HI 88713-11 Calibration set for turbidimeter(<0.1, 15, 100 750 FNU and 2000 NTU)
OTHER ACCESSORIES
HI 731318

Tissue for wiping cuvetets (4 pcs.)

HI 731331

Glass cuvettes (4 pcs.)

HI 731335N

Caps for cuvettes (4 pcs.)

HI 92000

Windows

compatible software

HI 93703-50 Cuvettes cleaning solution (230 mL)

ACCESSORIES

PC INTERFACE

Log data download from the instrument to the PC can be done with the HI 92000 Windows compatible
software (optional). HI 92000 also offers graphing and on-line help features. Data can be exported to the
most popular spreadsheet programs for further analysis.
To connect your instrument to a PC, use a standard USB cable. Make sure that your instrument is switched
off. Plug one connector to the instrument’s USB socket and the other to the USB port of your PC.
Please reffer to the HI 92000 software to download the data from the instrument.

Beeper
Option: Enabled or Disabled.
This option is used to enable/disable the beeper.
Press the “Enable” functional key to enable or
disable this option.
When enabled, a short beep is heard every time a
key is pressed.
A long beep alert sounds when the pressed key is
not active or an error condition is detected.

Instrument ID
Option: 0 to 9999.
This option is used to set the instrument’s ID
(identification number). The instrument ID is used
while exchanging data with a PC.
Press “Modify” functional key to access the
instrument ID screen. Press the UP or DOWN key
in order to set the desired value. Press “Accept”
functional key to confirm the value or ESC to return
to the setup menu without saving the new value.

Meter information
Press “Select” functional key to view the Instrument
model, firmware version, language version and
instrument serial number.
Press ESC to return to the Setup mode.

Before using this product, make sure that it is entirely suitable for your specific application and
for the environment in which it is used.
Operation of this instrument may cause unacceptable interferences to other electronic equipments,
requiring the user to follow all necessary steps to correct interferences.
Any variation introduced by the user to the supplied equipment may degrade the instrument’s
EMC performance.
To avoid damage or burns, do not put the instrument in microwave ovens. For your own and the
instrument safety do not use or store the instrument in hazardous environments.

RECOMMENDATIONS FOR USERS

WARRANTY

HI 88713 is warranted for two years against defects in workmanship and materials when used for
its intended purpose and maintained according to the instructions.
This warranty is limited to repair or replacement free of charge.
Damage due to accident, misuse, tampering or lack of prescribed maintenance is not covered.
If service is required, contact your dealer. If under warranty, report the model number, date of purchase,
serial number and the nature of the failure. If the repair is not covered by the warranty, you will be notified
of the charges incurred.
If the instrument is to be returned to Hanna Instruments, first obtain a Returned Goods Authorization
Number from the Customer Service Department and then send it with shipment costs prepaid. When
shipping any instrument, make sure it is properly packaged for complete protection.
To validate your warranty, fill out and return the enclosed warranty card within 14 days from the date of purchase.