Hanna Instruments HI 253 - Manual (Page 24)

24
Press the ARROW keys to change the ion charge.
Note:
To select the right ion charge, different ion types and their charge are
presented in the table below.
Press CFM to save the modified ion charge.
Press CAL to escape without saving.
BEEP STATUS SET
Press CAL when the beep status is displayed. Beep status (On or OFF) will
start blinking.
Press the ARROW keys to change the beep status (On or OFF).
Press CFM to save the modified beep status.
Press CAL to escape without saving.
BAUD RATE SET
Press CAL when the baud rate is displayed. The baud rate (600, 1200, 2400,
4800 or 9600) will start blinking.
Press the ARROW keys to change the baud rate value.
Press CFM to save the modified baud rate value.
Press CAL to escape without saving.
E G R A H C N O I s e p y t N O I
2 – ) s n o i n a t n e l a v i d ( O C , S
3
1 – ) s n o i n a t n e l a v o n o m ( O l C , N C S , N C ,I ,r B ,l C ,F
4
O N ,
3
1 ) s n o it a c t n e l a v o n o m ( H N , g A , K , a N
4
2 ) s n o it a c t n e l a v i d ( b P , u C , d C , a B , a C , g M
F d n u n o i d e n if e d n u