Hall Research HR-733-S - Manual (Page 15)

HDMI, VGA/YPbPr, and Serial over Single Fiber
13
1200 None None
2400 Odd
4800 Even
9600
19200
38400
57600
115200
Figure 13 – RS-232 Settings Menu
NOTE
If there is no user activity for 1 minute, the idle menu will be
shown and LCD backlight will be off. Pressing any button will
take the user back to the previous menu.
6.3 LCD Menu Detailed Descriptions
The following paragraphs explain in further detail the function of each menu
choice. The numbers in parenthesis () refer to the corresponding menu level in
figures 6 through 13 in the previous section.
(1) SOURCE SELECT – This menu allows the user to select one of the three
input sources: HDMI/DVI #1, HDMI/DVI #2, or VGA/YPbPr.
(2) VGA/YPbPr ADJUST – This menu gives the user the ability to fine-tune the
way input #3 (VGA or component YPbPr) is converted into an HDMI or DVI
signal. The unit can embed an associated audio in to the video. The audio can be
either L/R analog on 3.5mm mini stereo or digital SPDIF on TOSLINK connector.
(2.1) INPUT TYPE – This is used to specify the type of analog video
that is going to be fed to the unit. Select either a PC analog VGA or
(4.3a)
(4.3)
(4)
(4.2a) (4.1a)
(4.2) (4.1)
RS232 SETTINGS
RS232 BAUD
19200
RS232 PARITY RS232 FLOW CTRL
CCTRL
None None