Hall Research UVA-8 - Manual (Page 9)

4 or 8 Channel Splitter PC Video & Audio over Twisted-Pair Receivers
7
3.3 Advanced Brightness Adjustment on URA Receivers
The URA series of devices can equalize the brightness of the video by reducing
smearing.
• Apply power to the receiver. Wait until all LED’s are turned off
• Press the SEL button once to enter Adjustment-mode.
• In Adjustment-mode, all three (3) LEDs will be ON solid.
• Press and hold the SEL button for at least 3 seconds to enable the
Video Brightness Adjustment Mode (previously called Wire Gauge
Mode).
• In Video Brightness Adjustment Mode, the GREEN and BLUE
LED’s will be blinking.
• The UP button raises the video brightness level.
• The DOWN button lowers the video brightness level.
• Pressing BOTH the UP and DOWN buttons at the same time will
reset the Video Brightness to the default setting.
• While using the UP and DOWN buttons, if an upper or lower limit of
the adjustment is reached, the brightness will no longer change with
each button press.
• To exit the Video Brightness Adjustment mode at any time, press
the SEL button until all LED’s are ON solid (Adjustment-mode).
Press the SEL button repeatedly until all LED’s are OFF indicating the
unit is ready for operation. (The unit will automatically return to this
mode after 1 minute if no buttons are pressed).
Note
The Video Brightness adjustment may not be noticeable when only using 1 device.
When products are daisy-chained using the –XT version the adjustment is easier to
observe.