Hall Research VSM-404 - Manual (Page 6)

Model VSM-404
4
2. Installation and Configuration
To set up your VSM-404 Video Matrix Switch system, take these steps:
1.
Making sure that the Switch is powered off, find its input ports.
(These are the top row of HD15 connectors on its rear panel.
Run cabling from these ports to the video-output ports of the PC
CPUs or
other devices that will be providing the Switch’s video input.
If all of these input devices are transmitting VGA/SVGA/XGA-type
video signals on HD15 female connectors, you can use standard VGA
video extension cables such as our product CVGX-xx-MM. Keep in
mind that the length of any of these cables plus the length of any of
your monitor/output cables (see step 2) should not be more than 150 ft.
If any of your input devices transmit some other type of video signal
and/or use some other type of video connector, you might need special
cables or adapters; call HRT Technical Support.
Figure 2-1. The Switch’s rear-panel components.