Hall Research UHBX-3S - Manual (Page 5)

UHBX-3S
5
3.0 Setup
3.1 Package Contents
All UHBX-3S units are shipped with +5V power supply, a 1m HDMI cable and
a male-to-female RS-232 cable.
3.2 Installation
Figure 3 – UHBX-3S Application Diagram
As shown in the diagram above, UHBX-3S is used to extend a single video
source to three (3) remote displays, located within 500 ft (150 m) from the
source. It also provides an additional HDMI output for connection to a local
display or for daisy chaining to another UHBX-3S for more HDBaseT outputs.
When the UHBX-3S is used with UHBX-R-PD receivers, the RS-232 and Power
(PoH) signals are also extended on the same Cat 6 cable. The RS-232 In port is
used to send/receive commands or data to/from remote displays connected at the
output. Special RS-232 commands are provided to selectively communicate with
any individual output (Please refer to Section 5 for more details.).
Note: By default the output port numbers are assigned address 1 through 3. If
RS-232 ports are daisy chained among several UHBX-3S devices then the user
must assign different port numbers to each box so each HDBaseT output has a
unique address. In order to do this the user must connect each additional box to a
PC using the supplied using a USB cable (cable is type A to mini-USB) and
utilize the "UHBX-3S Manager Software" available for download from Hall
Research website.
Multiple UHBX-3S boxes can be daily-chained together as shown below.
UHBX-R-PD
UHBX-R-PD
UHBX-R-PD
Remote
Display 1
Remote
Display 3
Video
Source
PC
Cat 6
Cat 6
Cat 6 Remote
Display 2
+5V +48V
Local
Display
HDMI Cable
RS-232 Cable
USB
Mini
USB
HDMI
In
HDMI
Out
2
1
3
RS-232
In (F)
RS-232
Out (M)
UHBX-3S
USB is only required
to assign Output port
numbers & to manage
EDID.