Hall Research UHBX-3S - Manual (Page 4)

UHBX-3S
4
additional +48V power supply must be connected to UHBX-3S. Note that the
+48V power supply is not included with the UHBX-3S.
UHBX-3S also works with UH-1BT-R and the UH-1BTX-R receivers. As
shown in Figure 2 below. In this case each receiver is powered locally and the
+48V power supply is NOT required at the sender.
Figure 2- UHBX-3S paired with UH-1BT-R (or UH-1BTX-R) receivers
2.0 Features
• Splits HDMI for up to 3 remote displays using HDBaseT™
• Local HDMI output for connection to a display or daisy-chain to another
splitter
• Extends HDMI, Power (PoH), and RS-232 signals over single Cat 6
cable up to 500 ft (150 m) max.
• Supports all HDMI & DVI resolutions with ability to extend 4Kx2K &
deep color video up to 100m (330 ft) OR 1080p HDMI video & DVI
video up to 150m (500 ft).
• Advanced EDID management with USB port for EDID manipulation
using a PC
• Can address and send independent RS-232 commands to each HDBaseT
output.
• RS-232 commands can be sent at any baud rate up to 115200
• Complies fully with HDBaseT standard
• Power-over-HDBaseT(PoH) meets IEEE 802.3af standard
• RS-232 expansion port for daisy-chaining multiple UHBX-3S units
• Fully isolates ground between TX and RX sides
• Sturdy metal enclosures with mounting provisions