Glow-worm Hideaway 40CF - Manual (Page 19)

19 221807B
CAPILLARY REMOVAL Diagram 9.7
CAPILLARY
CABLE CLIPS(2)
ELECTRICAL CONNECTIONS Diagram 9.6
FLUE
BLOCKAGE
SAFETY
DEVICE
0904/A
5041
ELECTRICAL
CONNECTIONS
SECURING
LOCKNUT
CAPILLARY
FLUE
BLOCKAGE
SAFETY
DEVICE
9 Replacement of Parts
INSULATION PANELS Diagram 9.5
SIDE
INSULATION
PANEL REAR
INSULATION
PANEL
1670
GRAPHITE
COATED
NUT
SCREW
CLIP
BAFFLE
TRAY
9.7 Pilot Burner
Follow the instructions in the relevant parts of Section 8.1 to
remove cover and burner controls assembly.
Remove the lint arrester as in Section 8.2.
Disconnect the thermocouple nut at the pilot burner, see diagram
9.3.
Disconnect the nut retaining the pilot tube and injector in the
pilot burner.
Remove the two screws and nuts securing the pilot burner and
the shield front cover, see diagram 9.3.
Check that the pilot flame length is as shown in diagram 7.3.
Replace thermostat phial as Section 8.1.
Replace lint arrester as Section 8.2.
9.8 Insulation Panels
Follow the relevant instructions in Section 8.1.
Unfasten the two screws retaining each side insulation panel
within the combustion chamber and remove panel, see diagram
9.5.
Release the rear insulation panel upper clips and lift out panel.
Replace thermostat phial as Section 8.1.
9.9 Injector
When the burner has been removed from the injector manifold
as in Section 8.2 the injector can be unscrewed from the
manifold and renewed as necessary.
When replacing use a little jointing compound on the external
threads only, to make a gas tight seal.
Replace thermostat phial as Section 8.1.