GlowShift Volt Gauge - Manual

Tinted Series Volt Gauge
For Product Numbers: GS-T05
Wire Harness Color Code
Red: 12v Ignition Source (+) (switched) Orange: 12v Switched Headlamp Source (+) (optional)
Black: Vehicle Ground ( - )
1. Disconnect the vehicle's negative battery cable.
Gauge Installation
2. To make the wiring of your gauges easier you can purchase
an expandable circuit. This component easily fits into your
fuse panel and provides an additional fused power wire for
accessories such as gauges. The expandable circuit is available
for purchase at www.GlowShift.com.
3. Using automotive grade wiring (18 gauge); connect the red
wire to a positive 12 volt ignition (switched) source. It may
be connected to the fuse panel, an accessory wire, or any
positive 12 volt source that turns on and off with the ignition.
4. Using automotive grade wiring (18 gauge); connect the
black wire to any good (unpainted) ground connection. You
may also route a wire directly to the negative side of the
vehicle’s battery.
5. The Night Time Dimming feature decreases the brightness
of the gauge face by 30%. Connect the orange wire to the 12
volt positive headlamp source. This allows the mode to be
activated when the headlights come on. This step is optional
and will not affect operation of the gauge if it is omitted.
 Note: Do not connect the orange wire to a dimmer
wheel. This will cause the gauge lighting to flicker.
6. Reconnect the vehicle's negative battery cable.
 Power on the vehicle to ensure the gauge is functioning
properly.