GlowShift 7 Color Series Vacuum Gauge - Manual

7 Color Series Vacuum Gauge
For Product Numbers: GS-C703, GS-T703 and GS-W703
Wire Color Code
Yellow: 12v Constant Source (+) (un-switched) Black: Vehicle Ground ( - )
Red: 12v Ignition Source (+) (switched) Orange: 12v Switched Headlamp Source (+) (optional)
1. Disconnect the vehicle's negative battery cable.
Gauge Installation
2. Run the vacuum line from the gauge through the firewall.

Note: Make sure the vacuum line is not pinched; the use
of a rubber grommet through the firewall is required.
3. Cut any vacuum line and insert the included T-fitting between
the two cut pieces of vacuum line. Insert accordingly so that the
intersecting cross piece of the fitting with the brass pressure
restrictor is left to be connected to the vacuum gauge line.

Note: If a vacuum line is not available to cut, you may
need to purchase a brass barbed fitting (with restrictor) to
install into the intake manifold to obtain a vacuum
pressure reading. This fitting can be purchased at
www.GlowShift.com.
Connecting the Power Wire Harness
4. To make the wiring of your gauges easier you can purchase an
expandable circuit. This component easily fits into your fuse panel
and provides an additional fused power wire for accessories such as
gauges. The expandable circuit is available for purchase at
www.GlowShift.com.
5. Using automotive grade wiring (18 gauge), connect the yellow
wire to a positive 12 volt constant (un-switched) source either on
the vehicle or in the fuse box.

Note: If you are connecting the yellow wire directly to
the battery, you MUST install a 3 amp fuse within 6-8
inches of the battery connection.
6. Using automotive grade wiring (18 gauge); connect the red wire
to a positive 12 volt ignition (switched) source. It may be connected
to the fuse panel, an accessory wire, or any positive 12 volt source
that turns on and off with the ignition.
7. Using automotive grade wiring (18 gauge); connect the black wire
to any good (unpainted) ground connection. You may also route a
wire directly to the negative side of the vehicle’s battery.
8. The Night Time Dimming feature decreases the brightness of the
gauge face by 30%. Connect the orange wire to the 12 volt positive
headlamp source. This allows the mode to be activated when the
headlights come on. This step is optional and will not affect
operation of the gauge if it is omitted.

Note: Do not connect the orange wire to a dimmer wheel.
This will cause the gauge lighting to flicker.
9. Reconnect the vehicle's negative battery cable.

If your gauge(s) do not illuminate or do not recall your last
saved color, your switched and un-switched sources are
reversed.

If your gauge(s) only illuminate red then the yellow wire for
constant source is not connected properly.

Be sure all of your wiring is correct to ensure proper gauge
operation.