FeiYu Tech FY-X4 - Manual (Page 6)

GuiLin FeiYu Electronic Technology Co., Ltd
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
Page 5
The Magic cable tie use for fixed battery.
The frame Power detection support 3S (11.1V )battery. Connect a 3S Lipo Balance plug to the plug on the
bottom of the Fuselage.
Power detection: Fuselage Led flash.
Status LED on Slow flash Medium flash Fast flash
battery >11.5V 11.1V~11.5V 10.8V~11.1V <10.8V
note Enough power Voltage
reduction
Need landing Landing
immediately
Step 4: Installing the ESC’s and the Battery connector.
Take the four esc’s out of their package, This is an important step to be observed. On three of the esc’s,
remove the “Red” positive lead from the servo connector. Place a small piece of Shrink tubing over the
wire as not to cause a short.
This is done as the FY91Q and the Compass module needs only one power source..
Connect the three blue wires with the female connectors to the motor leads. As for now you don’t need to
worry about direction the motor is turning.
Do this for all four motors and esc’s. Running the wires between the pillars and the sides of the frames,
poke the servo connectors up through the top Fuselage plate at each point corresponding to each motor.
Run each JST Battery male plug through the same hole as the servo lead.
Insert the male plugs from the Battery plug assembly as indicated on the photo, attach each Female JST to
each of the plugs.
M3×25mm Pillar
M3×30mm Pillar
M3×5mm
Scoket Screw
Power cable through
Round hole
4 ESCs wire
through out
Front