FeiYu Tech FY-X4 - Manual (Page 3)

GuiLin FeiYu Electronic Technology Co., Ltd
GuiLin FeiYu Electronic Technology Co., Ltd http://www.feiyudz.cn E-mail: [email protected]
Page 2
Install
Tools needed to build the X4:
 Soldering Iron
 Rosen Core Solder
 Allen Wrench (provided)
Step 1:Frame Arm Assembly
Note: There are three LED on the side of arm,The LED should on out side.
Frame Arm Assembly
Unpack the Frames, separate them as to color of l.e.d.’s i.e. Blue, Red, Green.
Remove the m3x5mm button head screws.
Remove the m3x30mm pillars.
Unpack the four motor mount plates.
Unpack the four motors.
Unpack the four landing gears.
Take a motor mount plate and using the allen wrench provided, attach the motor to the plate with four
m3x5mm button head screws. Lay this aside.
Take four m3x30 mm pillars, using the allen wrench and m3x5mm button head screw, attach the four pillars
to the holes in the side frame. Make sure that the led’s are facing to the outside. Take the opposite side
frame making sure the led’s are facing outwards and the Weld points are on the same end. Do not tighten
the screws yet, Now take the motor with it’s mount and position it in the bottom slots that are cut in the side
frames, snug down the button head screws for the motor. Now take the landing gear and position it so the
long end is pointing down. Now tighten all eight button head screws.
M3×5mm
Scoket Screw
M3*5mm
Scoket Screw
Brushless motro
prop
eller
Leg
Right Arm
Left Arm
soldering point
soldering point
M3×30mm Pillar