ENMET AM-5150 - Manual (Page 20)

AM-5150 ENMET Corporation
18
6.0 Accessory and Replacement Parts
ENMET accessory part numbers:
Description of Part Part Number
Sensor Marking, 109-4 03034-109
Sensor Marking, 812-4 03034-812
Sensor Marking, 813-4 03034-813
Sensor Marking, 018-4 03034-018
Sensor Marking, 019-4 03034-019
Sensor Marking, 821-4 03034-821
Sensor Marking, 830-4 03034-830
Sensor Marking, 832-4 03034-832
Zero Gas, 20.9% O2, 17 liter 03296-209
Span Gas
Cylinder of Calibration Gas Contact ENMET for part number
of target gas for each instrument.
See note below.
N OTE : The gases should be identical, or equivalent (correlation gas) to those used to initially calibrate the unit, unless you want
to recalibrate to a new gas or different concentration. In addition, calibration gases must be in a background of air; do
not use gases with an inert gas background (such as nitrogen or argon).
7.0 Technical Data and Specifications
Electrical Power 15 Amp fused branch circuit
100-240 V AC
0.45A, 50/60 Hz
0.6A, 24 V DC
Storage and Transport Temperature: -20
°
to +60
°
C (-4
°
to +140
°
F)
preferred 0
°
to +20
°
C (32
°
to 68
°
F)
Relative Humidity 10-99% RH, non-condensing
Atmospheric Pressure 20 to 36 inHg (68 to 133 kPa)
Operation Temperature: -15
°
to +40
°
C (5
°
to +104
°
F)
Relative Humidity 10-99% RH, non-condensing
Atmospheric Pressure 20 to 36 inHg (68 to 133 kPa)
Mechanical Dimensions: 7.1 x 5.1 x 3 in(180x130x75mm)
Weight: 2 lbs (0.9 kg)
Material: Polycarbonate
Strain relief: 3-6.5mm OD
Outputs Relays: SPDT
Resistive Load
Inductive Load
10A at 110 V AC 7.5A at 110 V AC
10A at 30 V DC 5A at 30 V DC
Analog: 4-20mA
Digital: RS-485-modbus
Audio: 105 dB at 30cm/12in
N OTE : All specifications stated in this manual may change without notice.