Dacor 65537 - Manual (Page 25)

Problem Solving
25 Use and Care Manual
Problem: May be caused by: What to do:
Make sure that both spray arms rotate freely. Make
sure that items do not obstruct movement of spray
arms. If necessary, clear any obstructions.
Spray arms do not rotate properly
Make sure holes in spray arms are not blocked. If
necessary, clear holes with a pointed object and
rinse under water.
Strainer blocked Check strainer. Clean if necessary.
Use only “dishwasher” detergent.
Excessive foam in the machine
Too much rinse aid in final rinse cycle. Adjust rinse
aid dispenser (see page 15).
Spotting and filming
(cont.)
Flatware incorrectly loaded Make sure items are not nested (see page 11).
Make sure that both spray arms rotate freely. Make
sure that items do not obstruct movement of spray
arms. If necessary, clear any obstructions.
Spray arms do not rotate properly
Make sure holes in spray arms are not blocked. If
necessary, clear holes with a pointed object and
rinse under water.
Incorrect detergent use Use only correct amount of dishwasher detergent
according to water hardness (see page 14) and the
wash program selected. Fill dispenser only when
ready to start the dishwasher. Do not use old or
caked detergent. Store dishwasher detergent in dry
place and in a closed container. Change the
dishwasher detergent if results are still poor.
Filter system Make sure filter system is clean and properly
installed.
Small particles
deposited on items
Low water pressure Check that water valve is fully open. Make sure
water pressure is between 20 and 120psi and flow
rate is 1.0 gpm minimum.
Dispenser lid blocked The lid may not be opening. Check for items
blocking it.
Old detergent Do not use detergent that is hard or caked in the
box. Use only fresh detergent. Add detergent to
dishwasher just before starting it.
Make sure that both spray arms rotate freely. Make
sure that items do not obstruct movement of spray
arms. If necessary, clear any obstructions.
Detergent left in
detergent
compartment
(Detergent
compartment will
not open)
Spray arms do not rotate properly
Make sure holes in spray arms are not blocked. If
necessary, clear holes with a pointed object and
rinse under water.