Dacor 65537 - Manual (Page 16)

Operating Your Dishwasher
16
Dishwasher
Starting Your Dishwasher
IMPORTANT: See the Getting to Know Your Dishwasher section for a
description of the various wash settings.
To wash or rinse the dishes:
1. Press one of the wash cycle buttons or the rinse button
on the control panel:
2. Press START/STOP. The numeric display will show the
length of the cycle in minutes.
3. Close the door.
4. Push on the door handle to make sure that the door is completely shut.
After a brief pause, the dishwasher will start.
When the wash or rinse cycle is completed, the dishwasher will make 3 short
beeps.
Adding a Dish After You Start
You can add a dish, if needed, after starting your dishwasher. Dacor
recommends that you only add items during the first 5 minutes of operation to
make sure they get clean.
To add a dish:
1. Open the door. The dishwasher will stop operating.
2. Wait a moment for the steam to clear.
3. Without touching any of the hot surfaces or racks, insert the item into
one of the racks, following normal loading instructions.
4. Close the door.
5. Push on the door handle to make sure that the door is completely shut.
After a short pause, operation will resume.
Stopping Your Dishwasher During Operation
CANCEL
To stop the current cycle and drain your dishwasher:
1. Open the door. The dishwasher will stop operating.
2. Press
CANCEL.
3. Close the door. After a short pause, you will hear the water in the
dishwasher begin to drain. Once the water is drained, the dishwasher
will stop.
IMPORTANT: If you press the CANCEL button twice, the dishwasher will
stop completely. The water inside the dishwasher will not drain.
NORMAL HEAVY RINSE CRYSTAL
CANCEL
SANITIZED
RINSE AID
DIAGNOSTIC
WASHING
RINSING
DRYING
CLEAN
FLOOR GUARD
START
STOP
NORMAL HEAVY CRYSTAL RINSE DELAY SANI
RINSE
SECURE CANCEL
START
STOP