Elenco Deluxe Snap Rover® - Manual (Page 31)

-30-
Project #39 Remote Control Left Lite
Project #38
OBJECTIVE: To use remote control.
Remote Control Right Lite
Build the circuit and connect the jumper wires as
shown. Turn on the remote control unit and extend
the antenna. Turn on the slide switch (S1) and use
the remote control levers to drive Rover around.
Press the buttons on the remote control to light the
white LED (D4), note that it shines to the side. The
left button will make it brighter.
If you push the press switch (S2), then the remote
control buttons do not light the LED.
OBJECTIVE: To use remote control.
Build the circuit and connect the jumper wires as
shown. Turn on the remote control unit and extend
the antenna. Turn on the right slide switch (S1) and
use the remote control levers to drive Rover around.
Press the buttons on the remote control to light the
white LED (D4), note that it shines to the side. The
left button will make it brighter.
Turn on the left slide switch to hear tones form the
sound & recording IC (U9).
+
C
h
a
n
n
e
l
sw
itc
h o
n remote
co
n
tr
o
l
u
n
it.
R
O
VER REAR
+
C
h
a
n
n
e
l
sw
itc
h o
n remote
co
n
tr
o
l
u
n
it. R
O
VER REAR