Elenco Deluxe Snap Rover® - Manual (Page 30)

-29-
!
WARNING: Moving parts. Keep face and eyes away from
the front of the disc launcher and from flying discs.
Project #37 Disc Launcher
Project #36
OBJECTIVE: To sounds and lights remotely.
Remote Control Flasher
Build the circuit and connect all the jumper wires as
shown. Be sure the deluxe receiver (RX2) and
remote control unit are set to the same channel and
turn on the slide swtich (S1). Lights in the Rover
body are blinking and a tone is heard. Use the
knobs on the sound & recording IC (U9) to adjust
the blink rate and tone.
Use the buttons on the remote control unit to stop
the sound or blinking.
OBJECTIVE: To send foam discs flying.
Build the circuit and place discs inside the disc
launcher (DL). Turn on the slide switch (S1) - nothing
happens yet.
Push the press switch (S2); a motor starts up, the
“eyes” start blinking, and the white LED (D4) lights. If
you hold down the press switch then the foam discs
will be launched into the air.
Position the launcher so that discs will not fly toward
people, animals, or objects.
+
R
O
VER REAR
R
O
VER REAR
C
h
a
n
n
e
l
sw
itc
h o
n remote
co
n
tr
o
l
u
n
it.