Echelon LonWorks USB Network Interface - Manual (Page 10)

4 L ON W ORKS USB Network Interface User’s Guide
Installing the OpenLDV Software
You should install the OpenLDV software before connecting the USB interface to
your PC. You must have Administrator privileges on your PC to perform the
installation. To install the OpenLDV software, follow these steps:
1. Check that your PC meets the requirements listed in the System
Requirements section on page i.
2. Insert the USB Network Interface Drivers CD into a CD-ROM drive.
3. The OpenLDV installer starts automatically. If it does not, run the
OpenLDV210.exe file on the CD.
4. Follow the on-screen instructions to install the software. If warnings
appear, choose to continue the installation. A reboot may be requested
when the installation is complete.
5. After you complete the installation, remove the CD from the CD-ROM
drive. Following this, you can connect the USB interface to an available
USB port on your PC, as described in the next chapter.
NOTE: For your ease of use, the OpenLDV installer includes and
automatically installs all required USB driver files. To use the USB
interfaces, you only need to install the OpenLDV software, as described in
this section.