EarthQuake W2700B - Manual (Page 14)

Operator's Manual
27-Ton Log Splitter, W2700
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST
Operator's Manual
27-Ton Log Splitter, W2700
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 CST 14
Engine Oil Recommendations:
Refer to Engine Operator’s Manual for further information.
Towing:
The log splitter is equipped with a safety chain and a coupler
that requires a 2-inch diameter ball. Before towing, the safety
chain must be secured to the hitch or bumper of the vehicle and
the tongue stand lifted and locked into the road transport posi-
tion. Local regulations should be checked regarding licensing,
lights, towing, etc. Read the "Warnings and Safety Precautions"
section of this manual for additional towing safety instructions.
STARTING INSTRUCTIONS:
1. Move the throttle lever to “FAST”. Always operate the engine
with throttle lever in the “FAST” position.
2. Move choke control lever to “CHOKE” position.
3. Grasp rope handle and pull slowly until resistance is felt.
Then pull rapidly to start engine and avoid engine kickback.
4. Allow the engine to warm up. If operating in warm weather,
move the choke control lever toward “RUN” in small incre-
ments over several seconds. For cold weather operation do
this procedure over several minutes. Operate with choke
lever in the “RUN” position.
5. To stop engine, move the throttle lever to the “STOP” posi-
tion.
note: the maximum governed speed on the engine is
preset at the factory to 3600 rpM no load speed. When
splitting wood, the throttle should be set at the maximum
setting to develop the horsepower required for the pump.
System Check:
With the correct amount of hydraulic fluid in the system, oper-
ate the cylinder ram all the way into the forward direction and
all the way in the return direction. SEE FIGURE 17 AND/OR
18. Check that the ram moves smoothly without jerking. Check
that there is no leaking of fluids at component ports, fittings, or
hoses. If leaking is found, tighten fittings or clamps until leak-
ing goes away. If leaking doesn't go away, contact Earthquake
Customer Service (800-345-6007 M-F 8:00-5:00 PM CST, or e-
mail [email protected]).
Your log splitter is now properly filled and ready for use. You
have the correct amount of fluid in the reservoir when you can
see the fluid through the fluid level viewing window.
Once the log splitter is filled with fluid, tighten the filler cap by
turning it all the way clockwise.
tip: if your ram still does not travel smoothly, there may still be air
in the hydraulic system or your fluid level is too low. if this is the
case, with the engine turned off, loosen the filler cap and move the
hydraulic control valve from the forward to return position a few
times to purge any air that may be trapped in the hydraulic system.
note: doing this procedure with the filler cap removed will cause
any air that is in the system to expel through the filler spout. Check
for proper fluid level.
Figure 18
Forward
Return