Transmitter unit, Use six d-cell alkaline batteries in transmitter, Transmitter error messages – Ditch Witch 250RT User Manual
Page 40: Red led with no tone, 250r/t operator’s manual
250R/T Operator’s Manual
Service - 39
Transmitter Error Messages
CMW
Transmitter Unit
Change Batteries
Use six D-cell alkaline batteries in transmitter.
1.
Open battery cover.
2.
Insert batteries as shown.
3.
Close cover and tighten battery cover.
4.
Check operation. If battery light is flashing
when unit is turned on, then one battery is
incorrectly installed or batteries are weak.
Transmitter Error Messages
Red LED with No Tone
If red LED flashes with no tone in direct connect or induction clamp mode, the unit has detected a short in
one of the leads or on the target line.
See also other documents in the category Ditch Witch Special machinery:
- JT5 (161 pages)
- JT922 (159 pages)
- JT9 (165 pages)
- JT20 (195 pages)
- JT1220 (201 pages)
- JT2020 (203 pages)
- JT25 (203 pages)
- JT30 (245 pages)
- JT60 (218 pages)
- JT100 (243 pages)
- AT Air Hammer (11 pages)
- TK Series Manual (61 pages)
- 8500 (77 pages)
- MR90 (121 pages)
- FT5 (28 pages)
- FM5 (57 pages)
- FM13V (46 pages)
- FM25 (67 pages)
- P80 (71 pages)
- OnGrade (63 pages)
- FX20 (100 pages)
- FX25 (119 pages)
- FX30 (149 pages)
- FX50 (141 pages)
- FX60 (157 pages)
- MV800 (111 pages)
- RT Line (115 pages)
- RT30 (97 pages)
- RT45 (203 pages)
- RT55 (177 pages)
- RT100 (161 pages)
- RT115 (252 pages)
- RT120 (223 pages)
- Zahn (105 pages)
- RT80 (203 pages)
- RT115 Q (193 pages)
- RT120 Q (211 pages)
- 100SX (50 pages)
- 410SX (131 pages)
- SK350 (77 pages)
- SK750/SK755 (81 pages)
- SK850 (107 pages)
- SK850 Footings Machine (107 pages)
- 150RT (55 pages)