Ditch Witch 250RT - Manual (Page 27)

Locate - 26
250R/T Operator’s Manual
Active Location
CMW
4. Rotate the receiver to determine which
direction the line runs.
5. Set receiver on the ground.
6. Press depth button when the line has been
located.
7. Continue to trace the line and take depth
estimates every few paces.
8. Retrace the line and mark with appropriate flags or paint.
Mark the Line
Sweep, focus, and trace all detected signals in the area. Mark line paths with colored paint or flags.
IMPORTANT: Receiver indicates the
best signal when the handle is
perpendicular to the target line.
IMPORTANT: When estimating depth
for pipe, depth shown is to the center
of the pipe.