Ditch Witch 250RT - Manual (Page 23)

Locate - 22
250R/T Operator’s Manual
Active Location
CMW
Active Location
Setup
Follow setup procedures for the type of locating you will be doing: direct connection, induction clamp, or
broadcast induction. Always check receiver battery level at startup. See “Controls” on page 13.
Direct Connection
To set up transmitter for direct connection:
1. Carefully push ground stake (3) into ground.
2. Plug cable into transmitter (2).
3. Connect black lead to ground stake.
4. Connect red lead to line (1).
5. Turn on transmitter.
Electric shock. The connection leads may give off an electric shock when plugged into
the transmitter. Avoid touching the metal ends of clips when the transmitter is switched on.
NOTICE:
• Electric shock or equipment damage can result if transmitter is connected to live electrical
conductors. Observe all company and national safety procedures.
• Turn off transmitter when connecting or moving ground stake.
• Always comply with company and national safety requirements. Use correct equipment and working
methods. Use and maintain proper safety equipment.
Explosion possible. Serious injury or equipment damage could occur.
Follow directions carefully.
Do not use equipment in areas where flammable gases may be present or near to radio-
controlled blasting operations.
ss0014c-d.eps
1 2 3