Ditch Witch FXT30 - Manual (Page 99)

Service - 98
FX30/FXT30 Operator’s Manual
50 Hour
CMW
®
Check and Adjust Fan Belt Tension
Check belt tension every 50 hours. Belt is properly
tensioned when it moves about 1/4-3/8” (7-9 mm)
when pushed at the long span (shown).
To adjust:
1. Loosen two alternator bolts (1).
2. Adjust position to allow belt to slip off.
3. Install new belt.
4. Adjust position to tighten belt.
5. Tighten bolts.
6. Check tension.
Check Radiator
Check radiator for dirt, grass, and other foreign
matter every 50 hours. Check more often if
operating in dusty or grassy conditions. Clean fins
with compressed air or spray wash.
Check Battery
Keep battery clean and free of corrosion. Apply
coat of grease to cable clamps after cleaning.
In cold weather, battery loses some starting ability.
Closely watch voltmeter for signs of battery
discharge.
If battery will not hold charge, see your equipment
dealer for replacement battery.
IMPORTANT: Be careful not to damage fins
with high pressure air or water.
IMPORTANT: Use battery disconnect switch
(shown) when servicing, welding, and during
long-term storage.
j33om035h.eps j33om035h.eps