DICE Electronics DICE interface for iPod Honda - Manual (Page 12)

Installation
12
Installation should only be performed by a qualified professional. Beware of sharp edges to avoid injury and exercise
caution when removing trims as they may break. The module should be placed at an accessible location to allow AUX cable
to be connected, such as in the glove box, the center console or under the front seat.
1 Pull vehicle into service bay.
2 Make sure that the radio code is available before disconnecting battery. Disconnect both battery terminals. These cables
must be disconnected during installation to ensure proper initialization of the module when it is connected.
3 Pull out the radio by removing surrounding trims and screws to access the CD changer connector. Most
trims can be removed by carefully pulling on the piece or using trim removal tools. Trim is usually held in place by
snap-in clips. Consult your dealership if additional information is needed on removing the radio.