Digi 9P 9360/9750 - Manual (Page 22)

I n t r o d u c t i o n
2 2 L x N E T E S U s e r ’ s G u i d e
To use a terminal client as non-root user, either you need read/write access to
/dev/ttyS or the client has to be setuid root.
Minicom
To configure minicom, start it as root by entering:
Go to “Serial port setup” and change the values to your environment.
Figure 3-4: Minicom settings
Next time start minicom as a standard user with:
Seyon
Start Seyon as a standard user by entering:
Go to “Seyon Command” window and press “Set”. In the “Settings” window you can
adjust the settings.
Unless otherwise stated, it is assumed your target is connected to the first serial
port (COM 1, ttyS0) of your host.
If you use another port, change the “ttyS”
to the appropriate number.
# minicom –s
$ minicom
$ seyon -modems /dev/ttyS0