Clay Paky GLOW UP - Manual (Page 2)

2 GLOW UP
0.2 LED
IP65
• Installation
Make sure all parts for fixing the projector are in a good state of repair. Make sure the point of anchorage is stable
before positioning the projector.
The safety chain must be properly hooked onto the fitting and secured to the framework, so that, if the primary
support system fails, the fitting falls as little as possible. If the safety chain gets used, it needs to be replaced with
a genuine spare.
• Minimum distance of illuminated objects
The projector needs to be positioned so that the objects hit by the beam of light are at least 0.2 metres (8”) from the
lens of the projector.
• Minimum distance from flammable materials
The projector must be positioned so that any flammable materials are at least 0.20 metres (8") from every point on
the surface of the fitting.
• Maximum ambient temperature
Do not use the project if ambient temperature (Ta) exceeds 40°C.
• IP65 protection rating
The equipment is fully protected against dust (first digit 6) and against jets of water (second digit 5).
• Protection against electrical shock
Connection must be made to a power supply system fitted with efficient earthing (Class I appliance according to
standard EN 60598-1).
It is, moreover, recommended to protect the supply lines of the projectors from indirect contact and/or shorting to
earth by using appropriately sized residual current devices.
• Connection to the power mains
A qualified electrician must perform connection to the power mains.
Check that the mains frequency and voltage correspond to the frequency and voltage for which the projector was
designed and indicated on the electrical data label.
This label also gives the input power. Refer to the latter to evaluate the maximum number of devices to be
connected to the mains to avoid overloads.
• External surface temperature
The maximum temperature that can be reached on the external surface of the fitting, in a thermally steady state, is
90°C (320°F).
• Maintenance
Before starting any maintenance work or cleaning the projector, cut off power from the supply mains. After switching
off, do not remove any parts of the fitting for at least 10 minutes. The lenses must be mounted and, if visibly
damaged, they have to be replaced with genuine spares.
• Photobiological Safety
CAUTION. Do not look directly at the light source.
Do not look at the light beam with optical devices or any other tool that could cause light convergence.
This product is intended for the following areas of application:
studios, stages, theaters, exhibitions, trade fairs, events, theme parks, entertainment venues, architectural lighting
and similar
Not suitable for household illumination
Not for residential use
SAFETY INFORMATION GLOW UP
t
c
90°C
t
a
40°C
EN
Risk Group 1
According to
EN 62471