Clay Paky GLOW UP - Manual (Page 13)

13 GLOW UP
3
Projector installation
- Fig. 3
The projector can be installed on the floor resting on specific rubber feet, on a truss, on the ceiling or wall.
WARNING: the safety chain must be installed except when the projector rests on the floor. (Code 105015/801 available upon request). This
must be secured to the projector support structure and then hooked to the fastening point at the centre of the base.
1
2
3
2
3
1 4
4
Connecting and disconnecting the power cord
- Fig. 4
When connecting the power cord the user can choose whether to use the GlowUp in one of the following ways:
1) Power cord connected for battery charge.
2) Power cord connected for projector power (thus bypassing battery operations).
The GlowUp cannot work in both ways simultaneously.
When the projector is powered by connection to the mains, it could be necessary to adopt appropriate measures to avoid EMI disturbances to broadcast
receiver equipment.
INSTALLATION AND START-UP