Cisco BBSM 1 - Manual (Page 9)

2-9
Cisco BBSM Hotspot 1.0 User Guide
78-15293-01
Chapter 2 Setting Up BBSM Hotspot
Running the Setup Wizard
Figure 2-6 Welcome Back Window
Caution Before continuing, make sure that your router is configured and connected to the Internet.
Step 9 Click Next. The Testing Internet Connectivity window appears and begins testing the connection from
BBSM Hotspot through the router to the Internet. A progress bar shows the test time remaining. The test
should take less than a minute. The Back and Next buttons are disabled until the test is complete.
(See
Figure 2-7 .)
• If the test is successful, a Test Success window pops up with a message telling you that the
connection test was successful. Click OK to close the window, then go to
Step 11 .
• If the test was unsuccessful, this message appears on the Testing Internet Connectivity web page:
“Setup Wizard was NOT able to verify Internet connectivity. Click Next to continue.” Go to
Step 10 .