Avalue ENX-PNV - Manual (Page 34)

ENX-PNV
34
 LBA/Large Mode [Auto]
Enables or disables the LBA mode. Setting to Auto enables the LBA mode if the device
supports this mode, and if the device was not previously formatted with LBA mode disabled.
Configuration options: [Disabled] [Auto]
 Block (Multi-Sector Transfer) [Auto]
Enables or disables data multi-sectors transfers. When set to Auto, the data transfer from
and to the device occurs multiple sectors at a time if the device supports multi-sector
transfer feature. When set to [Disabled], the data transfer from and to the device occurs
one sector at a time.
Configuration options: [Disabled] [Auto]
 PIO Mode [Auto]
Select the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
 DMA Mode [Auto]
Select the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1] [SWDMA2]
[MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2] [UDMA3] [UDMA4]
[UDMA5] [UDMA6]. Only [Auto] is showed if no SATA device is installed in the system.
 S.M.A.R.T. [Auto]
Set the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
 32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]