beautypg.com

System memory, Dimm sockets location, Memory configurations – Avalue ENX-PNV User Manual

Page 15

background image

User

’s Manual

ENX-PNV


15

1.4 System Memory

1.4.1

DIMM Sockets Location

The motherboard comes with two 200-pin Double Data Rate 2 (DDR2) SODIMM sockets.

A DDR2 module has the same physical dimensions as a DDR DIMM but has a 200-pin

footprint compared to the 184-pin DDR DIMM. DDR2 DIMMs are notched differently to

prevent installation on a DDR DIMM socket. The following figure illustrates the location of

the sockets:

1.4.2

Memory Configurations

You can install 256MB, 512MB, 1GB and 2GB DDR2 SDRAM DIMMs into the SODIMM

sockets using the memory configurations in this section.

 Installing DDR2 DIMM other than the recommended

configurations may cause memory sizing error or system boot
failure. Use any of the recommended configurations.

 Due to chipset graphic resource allocation, the system may

detect less than 2 GB system memory when you installed one 2
GB DDR2 memory modules.

 This motherboard does not support memory modules FSB less

than 667MHz.Make sure that the memory frequency matches the
CPU FSB (Front Side Bus). Refer to the Memory frequency/CPU
FSB synchronization table.