Avalue EPI-LX800 - Manual (Page 64)

EPI-LX800 Series
64 EPI-LX800 Series User’s Manual
3.5.2.4 First/Second/Third/Other Boot Device
The BIOS attempts to load the operating system from the devices in the sequence selected
in these items.
Item Description
Floppy Floppy Device
LS120 LS120 Device
Hard Disk 0/1 Hard Disk Device 0/1
SCSI SCSI
Device
CDROM CDROM Device
ZIP100 ZIP-100 Device
USB-FDD USB Floppy Device
USB-ZIP USB ZIP Device
USB-CDROM USB CDROM Device
USB-HDD USB HDD Device
LAN Network Device
Disabled Disabled any boot device
3.5.2.5 Swap Floppy Drive
While system has two floppy drivers installed, this item will be affected. This function is to
assign physical drive B to logical drive A.
Item Description
Enabled Assign physical drive B to logical drive A
Disabled No change
3.5.2.6 Boot Up NumLock Status
Select power on state for NumLock.
Item Description
On Enable NumLock
Off Disable NumLock
3.5.2.7 Gate A20 Option
Select if chipset or keyboard controller should control Gate A20.
Item Description
Normal A pin in the keyboard controller controls Gate A20
Fast Lets chipset control Gate A20
3.5.2.8 Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When enabled, the
typematic rate and typematic delay can be selected.
Item Description
Enabled Enable typematic rate/delay setting
Disabled Disable typematic rate/delay setting