Austroflamm Yan Xtra - Manual (Page 9)

english 7 Yan Xtra / Ray Xtra
Heating in-between seasons
If you heat the stove in between seasons, when the
outside temperatures are higher, the flue gases may
not be able to escape completely and this may lead to
disturbances in the chimney draught, especially if the
temperatures are rising suddenly. The stove has to
be charged with less wood then and the primary air
has to be increased so that the wood can burn down
faster (with visible flames) and thus the chimney
draught can stabilize.
Chimney fire
A chimney fire may occur, due to sooting and
deposits in the chimney, if wrong or humid fuel is
used. In case of a chimney fire close all air inlets on
the fireplace/chimney immediately and call the fire
brigade. Please have an expert inspect your chimney
for cracks and air-tightness after the burning out of
the chimney.
4. THE MOST IMPORTANT SPARES—OVERVIEW
Gaskets
Description No.drawing Part number
Gasket 10x5, L=2380 mm 10 718438
Gasket 16x8, L=2100 mm 11 718763
Keramott
Description No.drawing Part number
Bottom left, Keramott 1 719043
Bottom rear, Keramott 2 719045
Bottom right, Keramott 3 719044
Side component left, Keramott 4 719047
Rear, Keramott 5 719046
Side component right, Keramott 6 719048
Wood retainer, Keramott 7 719042
Baffle plate rear, Keramott 8 719049
Grate 9 716408
Other parts
Description No.drawing Part number
Yan Xtra door 12 771279
Door handle 13 771096
Yan Xtra door glass 14 771274
Glass cleaner ½ litre -- 640070
Stove lacquer -- 650002
Accessories
You can obtain floor plates of glass or steel or care products from your certified dealer.
IMPORTANT: Have defective parts replaced by your certified dealer. This will guarantee that your
stove functions properly and safely.
The fireplace must not be amended.
Maintenance
To clean the glass, please use a specialized product such as Thermohit glass cleaner. Lacquered
surfaces are to be cleaned only with a cloth (may be damp). Special cleaning agents should also be used
for stainless steel surfaces.
Cleaning
The stove, flue outlets and smoke pipes should be cleaned and inspected for deposits every year – if
necessary more often, e.g. after the cleaning of the chimney. The chimney also has to be cleaned
regularly by the chimneysweeper. Your chimneysweeper will inform you of the necessary inspection
intervals. An expert should inspect the stove annually.
Keramott numbering = installation instructions!