Austin Hughes IPM-01 User Manual

Page 36

www.austin-hughes.com

UM-IPM-01-Q213V2

P.32

< 5.2 > Replacement, Removal or addition for PDU & IP dongle

4. How to move out a PDU (without a replacement) ?

Step

1. Prepare an appropriate length Cat. 5/6 cable.

Step

2. Disable alarm email in page.

Step

3. Use the Cat. 5/6 cable to bridge over the removed PDU to minimize log/data loss.

Step

4. Power off & unplug the device(s) which connected to the PDU.

Step

5. Power off & remove the PDU from connection.

Step

6. Click Disable Monitoring in

page to stop monitoring the removed PDU.

Step

7. Enable alarm email in page.

If the removed PDU NOT in the last level, you MUST reconfi gure and reset the level for the

affected PDU(s) which next to the removed PDU.

Ignore step 1 & 3 if the removed PDU is in the last level.

5. How to add an extra PDU to an existing PDU group ?

Step

1. Prepare a PDU and set the PDU level accordingly.

(Please refer to P.1 for the PDU level setting )

Step

2. Prepare an appropriate length Cat. 5/6 cable.

Step

3. Disable alarm email in page.

Step

4. Install and connect the new PDU.

Step

5. Power on the new PDU.

Step

6. Click Search in page to search the new installed PDU.

Step

7. Confi gure the new PDU in and

page such as

Alarm Amp , Name, Location…

Step

8. Enable alarm email in page.

If the added PDU NOT in the last level, you MUST reconfi gure and reset the level for the

affected PDU(s) which next to the added PDU.

The company reserves the right to modify product specifi cations without prior notice and assumes no responsibility
for any error which may appear in this publication.

All brand names, logo and registered trademarks are properties of their respective owners.