Dynasty Spas D-2000 - Manual (Page 28)

PROTECT YOUR COVER
Proper Maintenance For Your Dynasty Spa Cover
2) Splash cool tap water on the hardware to free them if they become frozen
shut. WD-40 will keep the lock free, but apply carefully because it can
damage the cabinet finish.
3) We recommend a good treatment with Vinyl Conditioner before your first
snow or ice. If possible, treat during the winter too.
4) Monitor your water chemistry. Even it the spa is not used regularly, improper
water chemistry can cause a mildew build-up on the cover. Clean water and PH
controlled water will prolong the life of the cover.
5) If mildew is found, remove foam cores from the vinyl encasement. Mix water,
a teaspoon of mild dish washing soap and a cup of bleach. With a soft bristle
brush, scrub the inside and outside of the vinyl encasement thoroughly. Then
take a washcloth and wipe down each foam core, rinse thoroughly. Place
the encasement in the sun and foam cores in the shade to dry. Once
everything is thoroughly dry, spray the cores and encasement with a
mildew inhibitor (like Pine Sol). Allow to dry completely, then reassemble.
The key here of course is to maintain proper water chemistry to avoid mildew.
6) We suggest rotating the cover every six months to maintain even wear.
Unzip the cover, remove the foam cores, turn over and reassemble.
Ask Your Dealer About Using A Cover Caddy
1) Use a soft broom to remove accumulation after every snowfall or ice storm
W i n t e r i z i n g S p a C o v e r s
28