Dynasty Spas D-2000 - Manual (Page 17)

begins 1 minute after the spa is energized. The second filter cycle will begin
12 hours after the start of the first filter cycle. Filter duration is programm-
able at the topside panel for FILO, FIL1, FIL2, FIL3 FIL4 or filc - 24 hours.
The default filter setting is 2 hours. To program, press the WARM or COOL
pad then the pad. Press the WARM or COOL pad to select the filter
time duration. Press the MODE pad again to exit the programming sequence.
During filtration, the low-speed pump will run and the blower operates for 30
seconds at the start of the first filter cycle to clean out the air channel.
The heater will also run during filter cycles. An ozone generator (if installed)
will run 24 hours/day.
The jets and blower (if installed) can also be activated from an
auxiliary panel. The operation is the same as described for the main
panel.
Auxiliary Panel (optional)
When the water is at set temperature or below, the circulation pump (if
installed) runs 24 hours a day. However, it turns off a 2 F above set
temperature and comes back on for 1 hour every 3 hours until it reaches
set temperature again.
Press the LIGHT pad once for the light and the color wheel, again for the
light to pause on one color, and again to turn the light completely off.
The light will automatically turn itself off after 1 hour
Circulation Pump (optional)
Fiber Optic Light (optional)
Press the pad to switch between standard and economy mode.
Economy mode only heats the water during filter cycles. Standard mode
maintains the desired temperature at all times. We suggest using the
standard mode.
Standard and Economy Mode
To p S i d e C o n t r o l I n s t r u c t i o n s
Press the pad to turn the spa light on and off. The light will automat-
ically turn off after 1 hour.
Press the pad once to turn the blower on high. Press a second time,
blower is on low speed. Press a third time to turn off. The blower will
automatically turn itself off after 20 minutes.
Blower (optional)
Light
Your spa will automatically filter itself twice each day. The first filter cycle
Preset Filter Cycles
Press the pad then JETS 1. The panel will be locked, and the LED
will show
LOC
alternately with the water temperature. All automatic
functions will continue to operate. To unlock the panel, push then
JETS 1 again
Panel Lock
17